Products tagged with '5" reflector'

This is a factory refurbished non-modeling Lumedyne Head that has a 800ws AFSE standard flashtube in it. The Head's cable and connector are in good shape. The reflector is in reasonable shape and a diffusor cover is included. This Head has a one year warranty against any electrical or physical failure. However, while the flashtube is tested and working fine, it is not warranted.

This is a factory refurbished non-modeling Lumedyne Head that has a 400ws standard flashtube in it. The Head's cable and connector are in good shape, but the cable has been pulled on and doesn't retract to tight coils any longer. The reflector is in reasonable shape and a diffusor cover is included. This Head has a one year warranty against any electrical or physical failure. However, while the flashtube is tested and working fine, it is not warranted.

These colorful fabric covers are designed to fit any five to six inch reflectors and use elastic to stay on the front of the reflector. They cast a very even and smooth broadcast of colored light due to the thin cloth diffusion material. The colors can be seen in the photo as all kits are the same selection.

The AR5K is the normal size as we have used for all of these years which is five inches across. This reflector is black on the outside with a shiny silver finish inside. The kit includes a grid to keep the angle limited to about 40 degrees. A simple plastic diffuser cover is also included.

The ARWD is a silver five inch reflector and it has a shorter neck than the Standard one. That's why it sets further back from the flashtube and broadcasts a wider angle of coverage. This creates a wider broadcast of light within a one f-stop range with the first setting at a wide 80 degrees. In the first setting it is about as wide as the wider setting of the normal reflector but then it goes to extra wide 95 degrees coverage when it drops back into its dual notches.