Lumedyne, Inc.

This is a simple addition to a bracket when you want to be able to aim the Head up and down. There are two adjustable disks that allow you to set the ending angle in each direction. Some set screws allow you to adjust the range of movement and it is designed to bolt onto 1/4-20 holes or use the nuts and bolts.

The name says it all, except that there is a Sharpie™ marker included if you want to make permanent notes on this flat and writable tape measure that also works with a pencil for temporary notes. If you measure the light output at a given distance before your client is in front of you, then later when you are really shooting, it's easy to always get the exact right exposure without a lot of light-meter readings and extra flashes at your subject.

The ATTE goes into a Flash Head where the Flashtube normally goes and adds about an inch to the position of the Flashtube from the face of the Head. This is generally preferred when you need a different coverage from a custom reflector than the tube provides from it's normal location.

This coiled extension cord for the Lumedyne Heads is about 3 feet long before you start to stretch it and can easily stretch to about 7 feet. It has the silver round Head plugs at each end; one male for the Pack end and one female for the Head end. This is a direct Head Cord for the Signature Heads and an extension cord for the other Heads that have a cord already.

This is the normal replacement bulb for the glowing modeling light in the center of the Lumedyne Modeling style Flashtubes. It is about 25 watts bright and does use your battery at a rate of one 200ws flash per 20 seconds of modeling light use. It is user replaceable by simply first removing the flashtube then pulling the burned out bulb straight out. After carefully replacing the AMBR into its legs, the flashtube fits around it and plugs back into place.

This is the high performance replacement bulb for the glowing modeling light in the center of the Lumedyne Modeling style Flashtubes. It is about 25 watts but is almost 50% brighter than a normal Halogen bulb. So for the same drain as our other AMBR bulb this one is a bit brighter. It does also use your battery at a rate of one 200ws flash per 20 seconds of modeling light use. This AMBX bulb is also more durable against high temperature for extended use or high power flashes or rapid flashes where in all cases more than the normal heat is involved and a normal bulb would frost over white and fail due to overheating. It is user replaceable by simply first removing the flashtube then pulling the burned out bulb straight out. After carefully replacing the AMBX into the Head's legs, the flashtube fits around it and plugs back into place.